Dial Depth Gage SERIES 7 - 7200

Dial Depth Gage SERIES 7 - 7200

• Optimal for hole, narrow groove and step measurement.

Technical Data
Dial reading: 0.01mm or .001”
Flatness of base face: 5µm or 2µm
Contact point: Carbide-tipped ball point(needle point:7210, 7222)
Measuring force: 1.4N (2.5N: 7213, 7214, 7217, 7218)

Note:
*1
Caution should be exercised when exchanging a contact point of a Depth Gage (Dial/Digimatic Indicator)
• If a different size contact point is mounted, displacement of the contact point from the base contact surface will be changed and as a result, measurement range may not be maintained.
• A contact point cannot be mounted to a Depth Gage, if its diameter is too large for the hole diameter of the base.
• Parallelism adjustment with the bottom face of the base is required when mounting a flat contact point such as the flat/needle or carbide-tipped contact point.

*2
Caution on should be exercised when using an extension rod
• If the total length of the extension rod exceeds 110mm (4.5") use the instrument in a vertical position (contact point downward).
• Use a master gage (such as Gauge blocks) to perform zero-setting when the extension rod is mounted. (Master gage is an optional accessory.)

*3
Indicators
• Indicators for a Depth Gage is used for the Depth Gage. When the indicator is exchanged and extension rod is connected longer, the contact-point may incline signifcantly.
• Code No.543-400B / 543-402B for Depth Gage has a measuring force less than 1.5N.  

 Metric 

 Inch